Cosmic

The raddest thing in bike polo.


6 Comments

2nd Gear

Todd_2ndGearA few people were interested in my singlespeed tensioner plans so here they are.

Spinning around on the polo bike has been fine for such a long time yet I’m getting really tired of my 8 mile commute (one way) to work along with the ride to a court then home. 40GI takes it’s toll! What I needed was an extra gear with a  tensioner for commuting which can easily be removed when playing. A geared SS hub was out of the question. They weigh a ton.

I didn’t want a hanger welded on so after a bit of research found several hangers available. This one is the DMR Chaintug Hanger with the screw removed. It’s designed to fit over a 10mm axle and sits neatly in a horizontal dropout with an inner section which prevents it moving out of place. North Shore Billet make loads of solid ones too which look good. I’m using a 20t and a 14t on a cassette hub and long dropouts wouldn’t have taken all the slack.

In my case, these King axle bolts (female) have a 12mm thread so I had to file the hole in the hanger slightly. I also can’t remove the hanger with the wheel in the frame because of the 12mm thread. You won’t get this with 10mm axles or hubs with smaller threaded axle bolts. This Surly tensioner is so easy to adjust anyway that I can remove that each time and leave hanger in position (lazy mode). I can then remove the whole lot when packing into a travel bag. So no bent hangers.

I’m not sure if this is the easiest way to add that extra gear but i think I’ve pretty much nailed it according to the gearing I was wanting. Those long rides aren’t such a hassle anymore.

Keep It Cosmic!